Categorized | pressure washer hose

I have a Karcher electric pressure washer and water is coming out from the trigger area, what’s causing this?

Posted on15 March 2010.

Here is the one that I have:

http://www.karcher-usa.com/showproducts.php?op=view_prod&param1=232&param2=&param3=

when i turn the water hose on water comes out from the trigger area and it won’t stop. i made sure that there is a washer where the hose plugs into the unit also.

YOU HAVE A SEAL/RUBBER WASHER THT IS Terrible


6 Responses to “I have a Karcher electric pressure washer and water is coming out from the trigger area, what’s causing this?”

  1. paul c says:
    March 15, 2010 at 11:59 pm

    the o ring on the trigger is probably terrible
    References :

  2. rayandteewee says:
    March 16, 2010 at 12:16 am

    you have a terrible o-ring or a worn or defective valve.
    References :

  3. Frank Pytel says:
    March 16, 2010 at 1:06 am

    Water pressure.

    Question the right question please.

    God Bless
    References :

  4. Ron says:
    March 16, 2010 at 1:49 am

    It sounds like there is a restriction at the end of your gun. Take the nozzle off, on the sprayer, and see if it is plugged, if not ,do you have the gun turned off, so no water can go through?. If everything is clear, then there is a problem with the sprayer itself. Make sure all the lines are clear.
    References :

  5. whateverbabe says:
    March 16, 2010 at 1:59 am

    YOU HAVE A SEAL/RUBBER WASHER THT IS Terrible
    References :

  6. GrayWolf says:
    March 16, 2010 at 2:26 am

    Seals went terrible. Buy a new wand.
    References :

Trackbacks/Pingbacks


Leave a Reply


Advisory

Some of the products mentioned use affiliate links, for which we receive compensation when you make a purchase. In no case does this cause you to pay extra for a product, or cause us to give a favorable review or recommendation to a product that we think is inferior.

Wordpress Design and Development | Search Engine Optimization